KHK
Hypoid Gears
hypoid gear resemble spiral bevel gears except the shaft axes do not intersect. The pitch surfaces appear conical but, to compensate for the offset shaft, are in fact hyperboloids of revolution. Hypoid gears are almost always designed to operate with shafts at 90 degrees. Depending on which side the shaft is offset to, relative to the angling of the teeth, contact between hypoid gear teeth may be even smoother and more gradual than with spiral bevel gear teeth, but also have a sliding action along the meshing teeth as it rotates and therefore usually require some of the most viscous types of gear oil to avoid it being extruded from the mating tooth faces, the oil is normally designated HP (for hypoid) followed by a number denoting the viscosity. Also, the pinion can be designed with fewer teeth than a spiral bevel pinion, with the result that gear ratios of 60:1 and higher are feasible using a single set of hypoid gears. This style of gear is most commonly found driving mechanical differentials, which are normally straight cut bevel gears, in motor vehicle axles.
More information about the manufacturer >> KHK Hypoid gears
E-mail: Hi-Tech@medital.co.il
Company Tel: 073-2000280
Avihai Ben Naim
Mobile: 054-6707555
E-mail: avihai@medital.co.il
Direct Tel: 073-2000227
Ronen Sagi
Mobile: 054-6319985
E-mail: ronen@medital.co.il
Direct Tel: 073-2000231
Din Kosberg
Mobile: 054-3826374
E-mail: din@medital.co.il
Direct Tel: 073-2000245